Team Shelby: SC Heads - Team Shelby

Jump to content

Visit our other sites: Shelby American Shelby Store Shelby Licensing Shelby Engine Co. Carroll Shelby Foundation Shelby Goodyear




Close Open
Close Open
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic
  • Bookmark

SC Heads

#1 User is offline   427SnakeSC 

  • Member
  • Pip
  • View gallery
  • Group: Members
  • Posts: 18
  • Joined: 17-May 06
  • Location:Toronto, Canada
  • Interests:Classic Cars, Bikes, Boats. I have a CSX 4000 Series Cobra. CSX 4995. It is powered by a Keith Craft built 427 SO. Transmission is a David Kee 4 spd. toploader with a 3.54 rear end.
  • State or Province:On

Posted 06 April 2007 - 07:44 AM

In the original SC models of the 427 Cobras, were the heads aluminum or cast?
0

#2 User is offline   KBCobra 

  • Member
  • Pip
  • Group: Members
  • Posts: 39
  • Joined: 18-May 07
  • Gender:Male
  • State or Province:SC

Posted 16 April 2007 - 05:28 AM

View Post427SnakeSC, on Apr 6 2007, 10:44 AM, said:

In the original SC models of the 427 Cobras, were the heads aluminum or cast?


This might be a question that the gearheads over at Club Cobra can answer quickly for you.
0

#3 User is offline   KBCobra 

  • Member
  • Pip
  • Group: Members
  • Posts: 39
  • Joined: 18-May 07
  • Gender:Male
  • State or Province:SC

Posted 02 May 2007 - 11:06 AM

View PostKBCobra, on Apr 16 2007, 08:28 AM, said:

This might be a question that the gearheads over at Club Cobra can answer quickly for you.


Not a definitive answer, but some good info non the less. It appears that the SC had cast heads with only the full comps alum.?? ;)

http://www.clubcobra...=Original+Heads

This post has been edited by KBCobra: 02 May 2007 - 11:07 AM

0

#4 User is offline   427SnakeSC 

  • Member
  • Pip
  • View gallery
  • Group: Members
  • Posts: 18
  • Joined: 17-May 06
  • Location:Toronto, Canada
  • Interests:Classic Cars, Bikes, Boats. I have a CSX 4000 Series Cobra. CSX 4995. It is powered by a Keith Craft built 427 SO. Transmission is a David Kee 4 spd. toploader with a 3.54 rear end.
  • State or Province:On

Posted 19 May 2007 - 02:59 AM

Thanks, KBCobra. I ordered aluminum heads on the motor I am getting built, but I am having them painted black, the same color of the block to get that "correct" look. Thanks again.
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic
  • Bookmark

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users