Team Shelby: Hisssss Dyno run after JBA install - Team Shelby

Jump to content

Visit our other sites: Shelby American Shelby Store Shelby Licensing Shelby Engine Co. Carroll Shelby Foundation Shelby Goodyear




Close Open
Close Open

Shelby Racing Extras

Time Slip Central:
Add your Racing Results, Dyno Graphs, Time Slips and more here.

Shelby Garage:
Add your vehicle and list your modifications here.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic
  • Bookmark

Hisssss Dyno run after JBA install

#1 User is offline   Hisssss 

  • Fox body lover......
  • Pip
  • Group: Members
  • Posts: 339
  • Joined: 04-February 08
  • Gender:Male
  • Location:All over the world most of the time
  • Interests:Cars, Bikes, Guns, Bourbon, Rock……
  • State or Province:WA

Posted 29 May 2008 - 10:50 PM

So today after work I headed down to the tuner to get a few runs in on Hisssss and sort out my new tune and figure what I had really gained with the JBA exhaust install. I was hoping for 20 rwhp and around the same in tq, but thats not what I ended up with.
Posted Image

Here is the vid of the shop, and I think the second pull, we were still farting around with the A/F ratio, there are all kinds of cool toys in there... :yup:
http://www.youtube.c...h?v=ijiKf-M3ZJk

and here is what we ended up with,
543 RWHP-(no gain at all.. <_<) but did pick up about 30ftlbs of torq.. ;) to about 600rwtq. The torq curve was a bit better longer and flatter than last run without the LT headers too, which makes sense.
Posted Image
I was just a bit disapointed, but I expect the JBA exhaust to pay off when the Whipple makes its apearance... :spend:
Thoughts??

This post has been edited by Hisssss: 29 May 2008 - 10:57 PM

0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic
  • Bookmark

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users