[GT500WDE]

Ordered these valve and coil covers today. They are supposed to fit the 2010s. Thoughts?

http://www.fordracin..._p/m-6582-c.htm

http://www.fordracin..._p/m-6067-a.htm

Thanks...
WDE

[2010KonaBlueGT]

GT500WDE, on Nov 12 2009, 06:09 PM, said:

Ordered these valve and coil covers today. They are supposed to fit the 2010s. Thoughts?

http://www.fordracin..._p/m-6582-c.htm

http://www.fordracin..._p/m-6067-a.htm

Thanks...
WDE

I have the same combo in mind for my 20-10. The only problem I have is, how to get the build plate/sticker off of the OEM covers and onto the FRP covers.


Phill Pollard - Co. Springs, CO
2010 Kona Blue/White GT500

[GT500WDE]

2010KonaBlueGT, on Nov 12 2009, 07:15 PM, said:

I have the same combo in mind for my 20-10. The only problem I have is, how to get the build plate/sticker off of the OEM covers and onto the FRP covers.


Phill Pollard - Co. Springs, CO
2010 Kona Blue/White GT500

Dang. I didn't think about that. Will have to look into that.

[shelby001]

Try thin momofilment line & go slow should work.

[2010KonaBlueGT]

shelby001, on Nov 12 2009, 06:47 PM, said:

Try thin momofilment line & go slow should work.

It's a really thin aluminium sticker. I use a similar method to tag motors I build. I take a roll of aluminium tape and punch "P&S Racing" into a piece then stick it on the block. It's pretty much impossible to get off without distorting the sticker, and I do that for a reason. (so someone can't transfer it to another motor).

I've had success removing sticker goo using WD-40. I was thinking about spraying WD on the edges of the GT build sticker and letting it soak around the edges into the goo, then GENTLY pulling the sticker off, re-gooing and putting it on the new covers.

I just wanted to wait until somene else found success before I screwed MINE up! LOL

I"m still waiting.....


Phill Pollard
2010 Kona Blue/White GT500